This makes it where you aren't physically cutting ignition wires in half so you know the car will still start. Step 1 is always find a wiring diagram. This can be the diagrams from an autoparts store if you can read those to ones found online. Generally automakers use the same color-codes for all their cars.
As far as the door unlocking and trunk popping, I'm sure your wifes car already has those functions on her existing FOB, so you don't really need to worry with connecting those unless you just want to. That feature was added so people didn't have to carry two fobs on their keychains when they used the remote start, but now most all fobs are made directly to the keys, so it doesn't make any difference.
The setup most likely has brake sensors and a hood pop sensor as safety features. If so, one wire would connect to the lead going to the brakes again, wiring diagram that when the brake lights come on it kills power to the engine unless the key is in the ignition and in the "run" position.
The hood pop sensor is most likely a pressure switch like on car doors, so if the hood is popped and someone tries to go anywhere it kills power as well.
For this just pop the wire through a grommet in the fire-wall, there should be some on both driver and passenger sides of the car, possibly right under the carpet. Run it to an open hole around the frame of the hood and screw it in, connect the wires and your good to go. I know this all sounds complicated but its really fairly simple. There is NO technical know-how needed, and I'd say with no experience wouldn't take more than a couple hours at most. Last edited: Aug 5, No problem, I hate seeing people spend money on something thats relatively simple just because it seems complicated.
As long as you know how to use a multimeter to check voltage before connecting wires, you can't hurt it. If it doesn't work as planned, simply disconnect the male and female ends and its back to normal. Press the brake pedal. The lights will flash 3 times. The rear defogger output will once again activate when the vehicle is remote started. NOTE: If the remote start is on the lights will turn off then flash 3-times before returning to their normal output and the defogger output will activate as programmed.
To activate: Park the vehicle and set parking brake. Page 20 Press Timer mode buttons. The vehicle will confirm with 4 parking light flashes. A 1-second delay will start. The system will start the car and will run for the specified duration, unless shut down by the remote start button. If shut down with the remote start button will remain in timer mode. Page Starter Anti-Grind Circuitry Starter Anti-Grind Circuitry Whenever the vehicle is remote started, advanced anti-grind cir- cuitry prevents the starter from engaging, even if the key is turned to the start position.
This prevents damage to the starter motor if the key is turned to the start position during remote start operation. If power is lost and then reconnected the system will recall the stored state from memory.
This means if the unit is in Valet Mode and the battery is disconnected for any reason, such as servicing the car, when the battery is reconnected the unit will still be in Valet Mode. Your system can be pro- grammed to either flash or to turn on the parking lights con- stantly during the entire remote start operation. Usually hidden under- neath the dash area of the vehicle. It houses the microprocessor which monitors your vehicle and controls all system functions.
Page Convenience Expansions Convenience Expansions Listed below are some of the many expansion options available for use with your system. Please consult with your dealer for a complete list of options available for use with this system. Domelight Supervision: The domelight will illuminate for 30 seconds each time the system is disarmed using the transmitter.
The T system will roll up two windows automatically when the system is armed, or roll two windows down by using the transmitter. The T will roll two windows both up and down. The LED will begin to flash. Your email address will not be published. In my opinion you are not right. I am assured. I suggest it to discuss. Write to me in PM. I consider, that you are mistaken.
Let's discuss. Write to me in PM, we will talk.
0コメント